Integrating Current Transformer & Beam Charge Monitor
ICT integrates bunch charge without loss
High sensitivity for pC resolution pulse measurement
BCM-IHR full scale ranges
400pC to 800nC
Noise in single bunch
ICT combines two nested transformers: a shorted one-turn current transformer loads the full bunch charge instantly into capacitors. Then the charge is transferred to the output by a readout transformer, at a slow pace, to avoid core losses. Cores are specially annealed to lower their coercive field and further minimize core loss. The ICT signal is integrated by BCM-IHR, a boxcar type synchronous differential detector. The output voltage proportional to the beam pulse charge is available 30μs after the trigger. It is maintained up to 400μs, then reset. Another pulse can then be measured.
In-flange ICT are mounted directly in the beam line. Available for many pipe diameters from 1” to 250mm. Also with elliptical aperture or other arbitrary shape aperture. Ceramic gap, shields and wall current bypass are included. Bellows are not required. Bakeable up to 185°C
In-air ICT installation, over the vacuum chamber requires installation of a “gap” to prevent the wall current from flowing through the ICT aperture.
The gap can be a brazed ceramic ring or an organic material O-ring depending on the vacuum requirements.
Typical installations include bellows, a wall current bypass and an electromagnetic shield enclosing the ICT completely.
BCM-IHR-E processes the signal from an ICT. Specially developed hybrid circuits amplify the charge and integrate it with low noise and high linearity. Output is a bipolar voltage directly proportional to the beam charge. A built-in Calibration Generator provides on-line assurance of measurement reliability. BCM-IHR-E inserts into a wired station of BCM-RFC, the 19” 3U RF-shielded chassis including power supplies. Up to 10 stations per chassis can be installed.
100°C (212°F) any time
100°C (212°F) any time 150°C (300°F) on option 185°C (365°F) on option
2 mT radial field 2A permanent DC current
Standard SMA PTFE: 1E3 Gray max Rad-tolerant SMA PEEK: 6E7 Gray max 1E17 n/cm2 max
From 0.5Vs/C to 20Vs/C
Full scale ranges (BCM)
800pC, using 5Vs/C ICT
400nC, using 0.5Vs/C ICT
Noise single bunch
±8V, available 50µs after trigger held for 350µs (up to 10ms on option)